Setting Conditions For The Gr4000 Models - Hitachi GR4000 Series Installation Manual

2.2

Setting Conditions for the GR4000 Models

Table 2.2-1 below outlines the basic conditions required to install the GR4000 models.
Users should place the devices in the environment where all of the following conditions
are satisfied.
When installing the device into a rack, the temperature inside the rack should be within
the range specified for the item "Temperature while running" in Table 2.2-1 below.
Table 2.2-1 Setting conditions for GR4000 models
Item
GR4000-
80E1
Dimensions (W x 440×490×
D x H)
230 (mm)
Weight 45 (kg)
Input voltage
AC100V（100V～120V）
Frequency
Input power 1000(VA)
required
Quantity of heat 900(W)
generated (max)
55 db or less 60 dB or less
Noise (Note 1)
Vibration
Dust (Note 2)
Temperature
while running
Temperature
while not running
Temperature
while shipping or
in storage
Humidity while
running
Humidity while
not running
Humidity while
shipping or in
storage
(Note 1) This should be checked 1 m away from the side panel of the unit.
(Note 2) Based on the measurement of falling dust.（See the section 2.7 Environmental Conditions.）
(Note 3) Based on the Japanese standard to measure the density of floating dust（JIS Z 8813）.
(Note 4) The figure in "( )" is a recommended value.
520-10-014-20X
GR4000- GR4000-320E
160E1 (AC)
440×490× 440×674×
441 (mm) 578 (mm)
80 (kg)
Single phase Single phase
(200V～240V)
50/60（±1Hz）
1800(VA) 4000(VA)
1700(W) 3800(W)
65 dB or less
5％/W or less（Note 2）or 0.15mg/m
0～40℃（23～28℃）（Note 4）
10～85％（45～55％）（Note 4）
5～85％（no condensation）
GR4000 Installation Guide Version 1.00 - Preliminary
Specifications
GR4000-
80E2
440×674×
147 (mm)
130 (kg) 40 (kg)
DC-48V（-40.5V～-57V）
AC200V
DC-60V（-50V～-75V）
1000(VA)
1000(W)
55 dB or
less
2
2.45m/s or less
3
or less（Note 3）
-10～43℃
-25～60℃
8～85％
GR4000- GR4000-320E
160E2 (DC)
440×674× 440×674×
289 (mm) 578 (mm)
70 (kg) 120 (kg)
-
2000(VA) 3800(VA)
2000(W) 3800(W)
60 dB or less 65 dB or less
59