Huawei R250D Hardware Installation And Maintenance Manual page 90

R250D

Hardware Installation and Maintenance Guide

Power Cable Label

Remove the label from the backing page, and attach it to the identification plate on the cable

tie. The label should be attached to the rectangular flute on the identification plate, and

attached to only one side of the identification plate. The cable ties are bundled at 2 cm (0.79

in.) from the connectors, and other positions are allowed in special circumstances.

Cable ties should be bound on both ends of a cable. After the bundling, the finished

identification plate should be on top of the cable in horizontal cabling, or on the right side of

the cable in vertical cabling, as shown in

Issue 01 (2016-09-30)

Figure 5-86 Label for signal cables

The identification card is to the right of the cable in vertical cabling.

The identification card is on the top of the cable in horizontal cabling. Make sure that the

label is facing out.

Huawei Proprietary and Confidential

Figure

5-87. The details are as follows:

5 Appendix

50082920