Connection Of Floppy Disk Drive - Mitsubishi Electric MELDAS 600 Series Connection Manual

4.2.3 Connection of Floppy Disk Drive

(1) Connection of F130 cable
Connect the floppy disk drive to CFD on the control unit. Refer to Appendix 2 (F130 cable) for the
floppy disk drive cable.
Control unit
CF11
Connect the F130 cable and floppy disk drive as shown below. Place the PCB side downward and
face the connector incorrect insertion prevention key upward when inserting.
F130 cable
(2) FDD installation conditions
The FDD body must be installed so that it is within ±25° of the vertical or horizontal directions.
The FDD cannot be used if the disk insertion port is inclined (other than vertical/horizontal).
Front face
CAUTION
Do not apply voltages other than those indicated in this manual on the connector. Doing
so may lead to destruction or damage.
Incorrect connections may damage the devices, so connect the cables to the specified
connectors.
CHAPTER 4 SYSTEM CONNECTION
4.2 Connection of Control Unit
F130 cable
CF D
Rear side of floppy disk drive
Power
supply
F D D
disk
Floppy disk drive
Signal
Power supply
Signal
Incorrect insertion prevention key
Within 25 °
Within 25 °
23
PCB side