4.2.5 Connecting of Hard Disk Drive
The procedures for connecting the hard disk drive are shown below.
(1) Open the control unit cover, and remove the HR841 card.
(2) Connect the control unit and hard disk with a cable.
(Note 1)
Use the cable enclosed with the hard disk. The max. cable length is 500mm.
(Note 2)
Take care when handling the hard disk drive. (Take care not to drop or shake the unit.)
When installed vertically, keep the inclination within 15°, and lead the cable from above.
CAUTION
Do not connect or disconnect the cables between each unit while the power is ON.
CHAPTER 4 SYSTEM CONNECTION
4.2 Connection of Control Unit
0
0
Refer to 4.2.5 (3).
25
HR841
Refer to 4.2.5 (3).