Preparing front connectors for I/O modules with shield contact element
You can find a video clip on the preparation all the way to wiring the front connector at the
following link
(http://cache.automation.siemens.com/media/67462859_wiring_shield_web_en/start.htm):
To prepare the front connector for wiring, follow these steps:
1. Remove the connection separator from the lower part of the connector (Figure 1).
2. Insert the power supply element (Figure 2).
3. Insert the shielding bracket from below into the guiding groove of the front connector until
4. Place the included cable strain relief (cable tie) for the cable harness into the front
5. Swing the front cover up until the front cover latches (Figure 5).
S7-1500 Automation System
System Manual, 02/2014, A5E03461182-AB
it latches into place (Figure 3).
connector (Figure 4).
Figure 6-8
Preparing front connectors for I/O modules with shield contact element (1)
6.8 Front connector for the I/O modules
Wiring
77