Siemens SIMATIC S7-1500 System Manual page 80

7. Wire the power supply element (Figure 8).
Wiring front connectors for I/O modules with shield contact element
1. Strip the cable shielding.
2. Begin to completely wire the front connector (Figure 1).
S7-1500 Automation System
System Manual, 02/2014, A5E03461182-AB
Terminals 41/42 and 43/44 are galvanically connected to each other. If you connect the
supply voltage to 41 (L+) and 44 (M), you can then loop-through the potential to the next
module with terminals 42 (L+) and 43 (M).
Figure 6-10 Preparing front connectors for I/O modules with shield contact element (3)
Figure 6-11 Wiring front connectors for I/O modules with shield contact element (1)
6.8 Front connector for the I/O modules
Wiring
79