Advertisement
Figure 25
Side view
Figure 26
Top View – Rear mounts (motors removed)
1. Weld the blocks 3/4 inches away from the edges.
Figure 27
Top View – Front mounts (motors removed)
1. Weld the blocks 3/4 inches away from the edges.
Side View – Front mounts (motors removed)
1. Weld the front motor blocks 1/8 inch over the edge.
Side View – Rear Mounts (Aligned with the edge; motors
2. Remove and discard the existing bolt and washer from
the thrust motor (Box A of
12
Figure 28
Figure 29
removed)
Figure
30).
Advertisement
