Advertisement
Figure 4
1. Measure here
2. Nut
5. Disconnect the hydraulic cylinder (Box B of
6. Remove the pillow-bearing assembly (Box C of
4).
Note: Discard the washer but keep the bolts and nuts.
7. Support the rod-loader assembly
8. Remove the hardware securing the cam assembly to the
machine (Box D of
9. Remove the cam assembly
10. Remove the wear pads and hardware connected to the
cam assembly as shown in
Figure 5
3. Bolt
4. Hydraulic cylinder
Figure
(Figure
1).
Figure
4).
(Figure
2).
Figure
5.
11. Assemble the new cam assembly using the wear pads
and bolts from the previous cam assembly and 14
flange nuts and 2 locknuts (M8) included in this kit
(Figure
12. Install the new cam assembly using the 3 bolts (M10-1.5
x 30 mm), 1 bolt (M10-1.5 x 35 mm), and 1 locknut
(M10) as shown in
1. Bolt (M10-1.5 x 35 mm)
and locknut (M10)
13. Connect the hydraulic fitting disconnected in step
(Figure
14. Install the hydraulic cylinder assembly using the bottom
bolt from the previous cam assembly and 1 flange nut
4).
from this kit as shown in
Figure
1. Flange nut
15. Torque the M10 bolts to 47 to 57 N-m (34 to 42 ft-lb).
16. Discard the washer that was removed during the
removal of the cam assembly in step 6; refer to Box C
of
Figure 4
4
5).
Figure
6.
Figure 6
2. Bolts (M10-1.5 x 30 mm)
3).
Figure
7.
Figure 7
and
Figure
8.
3
Advertisement
