Advertisement
Figure 30
1. Brace
2. Bolt (M12)
3. Washer
4. Spacer
5. Nut (3/8-16 inch)
6. Bolt (3/8-16 x 1 1/4 inch) rear motor assemblies
7. Bolt (3/8-16 x 1 inch) front motor assemblies
3. Lift the thrust motor and install the brace supports
(Box B of
Figure
30).
Note: The motor brace should be centered on the
thrust-motor flange.
Note: Loosen the fittings on the thrust-motor fittings,
if necessary.
4. Apply thread-locking compound to the 8 bolts (M12)
and loosely install the bolts, washers, and spacers into
the thrust motor assembly (Box C of
5. Install the nuts on the bolts, apply thread-locking
compound to the 4 bolts (3/8-16 x 1 1/4 inch), and
install the assembly into the rear motor assembly (Box
D of
Figure
30).
6. Install the nuts on the bolts, apply thread-locking
compound to the 4 bolts (3/8-16 x 1 inch), and install
the assembly into the front motor assembly (Box E of
Figure
30).
7. Place the motor brace centered against the thrust
motor flange and alternately tighten the adjustment
bolts (3/8-16) to 37 to N-m (27 to 33 ft-lb).
8. Tighten the jam nuts against the adjustment blocks.
9. Torque the 8 bolts (M12) to 90 to 112 N-m (67 to 83
10. Paint the welded area.
Installing the Proximity Switch
Bracket
Parts needed for this procedure:
Procedure
Clean off the paint, oil, and/or rust from the welding area.
1. Place the bracket 3 inches away from the rod box
Figure
30).
1. 1 3/4-inch gap
2. 3-inch gap
13
ft-lb).
6
1
Bracket
1
Plate flag
4
Bolt (M5-0.08 x 25mm)
4
Nut (M5)
2
Cable tie
mounting plate and 1 3/4 inches away from the bottom
of the carriage weldment to the top of the bracket and
weld the bracket to the thrust frame
Figure
32).
Figure 31
(Figure 31
and
3. Bracket
Advertisement
