Advertisement
1. Rear bracket
B. Adjust the pipe-return proximity sensor until the
light illuminates
C. Tighten the bolts and nuts on the sensor.
D. Torque the bolts to 791 to 971 N-cm (70 to 86
in-lb).
7
Installing the Caps and Decal
Parts needed for this procedure:
1
Valve cap
1
Monitor cap
1
Decal
Procedure
Install the decal as shown in
1. Decal
Remove the manual override valve screw and install the valve
cap as shown in
Figure
43.
Figure 41
2. Front bracket
(Figure
40).
Figure
42.
Figure 42
1. Valve cap
Gently lift the monitor away from the console using a flat
head screwdriver in the gaps as shown in Box A of
1. Gaps between the monitor and console panel
Insert the monitor cap into the port on the back of the
monitor and install the monitor back onto the console (Box
B of
Figure
44).
Connect the positive terminal of the battery then connect
the negative terminal.
16
Figure 43
2. Manual-override valve
Figure 44
Figure
44.
Advertisement
