Philips 50 T Series Service Manual page 46

Using the Service Program
Program S/N to
Transmitter
Program S/N to
Receiver
Power On Selftest
Show last errors/
warnings
Check Transmitter
Check Receiver
Read SerNum and
Revisions

Programs the Serial Number to the Transmitter (if no Serial Number is
present on the Transmitter). This feature is needed when the Transmitter
Printed Circuit Board is exchanged.
Follow the steps as the program requests.
When moving the service connector from one device to the other, a "SIO
RCV error" may be displayed. This is due to the PC's serial interface circuitry
and can be ignored.
If a Serial Number needs to be RESET, contact the factory Technical
Marketing Engineer to get RESET-CODE needed to RESET the Serial
Number.
Programs the Serial Number to the Receiver (if no Serial Number is present
on the Receiver). This feature is needed when Receiver-PC-Bd. is exchanged.
Follow the steps as the program requests.
When moving the service connector from one device to the other, a "SIO
RCV error" may be displayed. This is due to the PC's serial interface circuitry
and can be ignored.
If a Serial Number needs to be RESET, contact factory Technical Marketing
Engineer to get RESET-CODE to RESET the Serial Number.
The PC acts as a Terminal. The Transmitter or Receiver connected to the PC
must be switched OFF and then ON. The PC displays the Start-up messages
from the connected Transmitter or Receiver.
Shows the summary of the received Errors and Warnings.
Provides a Transmitter check of the following:
• detected modes
• status bits
• TOCO value
Provides a Receiver check of the following:
• detected modes
• status bits
• TOCO value
• RF field strength
When selected from the Main Menu, this sub-menudisplays:
• Software Revision
• Serial Protocol Revision
• Serial Number (S/N)
Chapter 6 - Using the Service Software