Philips 50 T Series Service Manual page 47

Reset Serial Number
Read country
information
EXIT
Chapter 6 - Using the Service Software
This feature is only available for HP Service Personnel. It allows you to reset
the Serial Number on the Transmitter or Receiver Board if the Serial Number
was programmed incorrectly.To use this section a Reset-Code from a factory
Technical Marketing Engineer is needed.
The Technical Marketing Engineer requires the following information:
• Serial Number (S/N)
• Transmitter OR Receiver
• Reason for RESET request
The Technical Marketing Engineer will provide you with:
The RESET-CODE.
Caution
Never erase the Serial Number from both the transmitter and the
receiver, as this status is not recoverable and requires factory assistance.
Displays the country information:
• International or
• France or
• Japan
• The RF-bandwidth
25 kHz ++or++ 12.5 kHz
• and when JAPAN
Japan ID-code
Exits the program.
Using the Service Program