Table of Contents
Advertisement
Error Message
Cannot Scan XX
Connection Error
Connection Failed
Cover is Open.
Data Remaining in
Memory
Document Jam/too Long
High Temperature
Ink Absorber NearFull
Ink Absorber Pad Full
Cause
The machine has a mechanical problem.
Other devices are trying to connect to the
Wi-Fi Direct network at the same time.
The Brother machine and your mobile
device cannot communicate during the
Wi-Fi Direct network configuration.
The scanner cover is not locked in the
closed position.
The ink cartridge cover is not locked in the
closed position.
Print data is left in the machine's memory. Press
The document was not inserted or fed
correctly, or the document scanned from
the ADF was too long.
The room temperature is too high.
The ink absorber box is nearly full.
The ink absorber box is full. These
components are periodic maintenance
items that may require replacement after
a period of time to ensure optimum
performance from your Brother machine.
Because these components are periodic
maintenance items, the replacement is
not covered under the warranty. The need
to replace these items and the time period
before replacement is dependent on the
Action
remains, contact Brother customer service
or your local Brother dealer.
Disconnect the machine from the power
for several minutes, and then reconnect it.
Make sure there are no other devices
trying to connect to the Wi-Fi Direct
network, and then try to configure the Wi-
Fi Direct settings again.
•
Move the mobile device closer to your
Brother machine.
•
Move your Brother machine and the
mobile device to an obstruction-free
area.
•
If you are using the PIN Method of
WPS, make sure you have entered the
correct PIN.
Lift the scanner cover and then close it
again.
Make sure the interface cable (if used)
has been guided correctly through the
cable channel and out the back of the
machine.
Firmly close the ink cartridge cover until it
locks into place.
. The machine will cancel the
job and clear it from the memory. Try to
print again.
Remove the jammed document, and then
press
. Set the document in the ADF
correctly.
See Related Information: Load
Documents in the Automatic Document
Feeder (ADF).
See Related Information: Document
Jams.
After cooling the room, allow the machine
to cool down to room temperature. Try
again when the machine has cooled
down.
The ink absorber box must be replaced
soon. Contact Brother customer service or
your local Brother dealer.
The ink absorber box absorbs the small
amount of ink emitted during print head
cleaning.
The ink absorber box must be replaced.
Contact Brother customer service or your
local Brother Authorised Service Centre to
have your machine serviced.
234
Advertisement
Table of Contents
