Table of Contents
Advertisement
* HDLC
* V.120
* X.75 (Transparent)
* X.75 (ISO8208)
************************************************************************************
key: Exit
Ctrl-W
Ctrl-U
key: move to previous item
key: move to next item
+, -
These protocols are used in the B channel and are used to set the packet size and
window size to meet the remote site configuration for connection compatibility or better
performance. For convenience you may store different settings into profiles 0 or 1.
You can select either of these profiles to speed up the configuration and usage.
Please refer to Chapter 4 for details of the AT command set and related information.
Installation for Windows 3.1 Environment
Installing and Configuring the Drivers
Run any terminal program such as Terminal, ProComm ... and configure the parameters
as follows.
Baud Rate:
Data Bit:
Parity Check:
Stop Bit:
Flow Control:
If you need to alter the default settings then please refer to the above section (How to
Configure TA-200).
SPID1, CODEC, MSN, and Outgoing telephone number will be stored in the adapter and
will not alter until customer changes them using the AT@ configuration screen.
Application Environment Setup
The ISDNL
TA-200 terminal adapter provides operation using standard AT commands
INK ™
through the COM port interface on you computer. It is therefore a simple matter to set up
existing application software to the appropriate COM ports to communicate with ISDNL
TA-200 terminal adapter. If you use TRUMPET to connect to Internet, you should add the
AT command (ATB4) before TRUMPET makes a connection to Internet. You can edit the
login.cmd file and add this command (ATB4) for Async-to-Sync conversion. If you do not
12
-- Packet Size : 2048
-- Packet
-- Packet
-- Packet Size : 128
Up to 115200
8
None
1
RTS/CTS
Please note, the set values of Country or switch type, SPID0 and
© COPYRIGHT OF ASUSCOM NETWORK INC.
Size : 256 Window Size : 7
Window Size : 7
Size : 1024 Window Size : 7
*
*
*
*
INK™
Advertisement
Table of Contents
