Table of Contents
Advertisement
+++
AT&ABn
AT&AB0
AT&AB1
AT&AB?
AT&APn
AT&AP0
AT&AP1
AT&AP?
AT&Cn
AT&C0
AT&C1
AT&Dn
AT&D0
AT&D2
AT&E
AT&E0
AT&E1
AT&F
AT&Kn
AT&K0
AT&K3
AT&K4
AT&K6
AT&Nn
AT&N0
AT&N1
AT&Tn
AT&TEST
AT&V
AT&W
AT&Wn
AT&Y
AT&Yn
Escape command (default)
Baud rate detection
Detect baud rate automatically, same as AT&B (default)
Disable auto-baud rate detection and fix to current baud
rate
Display the current baud rate
Incoming protocol detection
Disable incoming protocol auto-detection
Detect incoming protocol automatically (default)
Display the current setting
Control DCD
Keep always the DCD line ON ( the same as AT&C)
DCD line is active if connected (default)
Control DTR
Ignore the DTR, assume DTR always ON
DTR OFF will cause the ISDN TA to hang up (default)
Select the line speed in the B channel
64K bps (default)
56K bps
Reset registers to factory setting, default value
DTE/Modem Flow Control
Disable DTE/DCE flow control
Enable RTS/CTS DTE/DCE flow control (Default)
Enable XON/XOFF DTE/DCE flow control
Enable RTS/CTS and XON/XOFF DTE/DCE flow control
Select the voice type
Select the SPEECH as voice type (default)
Select the 3.1K Audio voice type
n = 0 for clearing the conformance test setting (default)
n = 1 for setting the loop back test for conformance test.
This command is used for PTT approval only.
Self-diagnosis of device
View profile
Write active configuration to profile n, n=0,1
Load profile n when power on, n=0,1
© COPYRIGHT OF ASUSCOM NETWORK INC.
29
Advertisement
Table of Contents
