Advertisement
5. Function Selection
(*1): Temperatures for Floor Exposed Type & Floor Concealed Types are not offset. Setting temperature are used as
they are.
(*2): The "02", "03", "04" settings may not be available depending on the type of indoor unit. When connecting
multiple indoor units, do separate settings.
(*3): Standard type.
(*4): It is not applicable for Auto mode.
(*5): If Duct type models, 00: Increasing fan speed 1 (standard), 01: Increasing fan speed 2 (high static pressure), 02:
Standard (low static pressure).
(*6): Since it depends on the model, please refer to the Service Manual of each model.
(*7): If the set temperature is changed and kept within the set time at "F4", the temperature is automatically changed
to "F5" and "F6". (If the set temperature is out of range at "F5" and "F6", it is applied within the upper and lower
limits for the set temperature.)
(*8): Applicable to the fan, cooling and dry operation modes.
(*9): Applicable to the heating operation mode.
(*10): When the unit is restarted by the controller, the temperature automatically changes to the setting temperature
of "F5" or "F6".
(*11): Available only for 4-Way Cassette Type, 4-Way Cassette Compact Type, 2-Way Cassette Type, 1-Way Cassette
Type, Ceiling Type.
(*12): Setting "P4" to "01", then the temperature of selected thermistor (sensor) can be shown.
(*13): Setting "01" can show sensor temperature selected in "P3".
31
Advertisement
