4
Connecting Cables
Cables must be routed in through cable clips.
Route and bind the cables along the beams and columns of the unit.
The cabinet has no input neutral wire. You can cut the blue neutral wire and wrap it using
insulation tape.
Cables can be routed from the bottom or side of the upflow units and cables can be routed
from the bottom, side, or top of the downflow units. Knock off the padding of holes at the
proper positions based on the onsite cable routing method, and route the cables through the
holes.
Connecting the Power Cable (Upflow)
4.1
Underfloor cabling/single power supply
Side cabling/single power supply
Underfloor cabling/dual power supplies
Side cabling/dual power supplies
15