Huawei NetCol8000-C070 Quick Manual page 8

5. Unscrew the pipe hold hoops using a 15# socket wrench, move the black sealing rings to the
other end of the pipes, and disconnect the pipes, as shown in the following figure. Save the
black sealing rings for later use during cabinet assembly.
6. Remove the quick release screws securing the cabinet, disassemble the cabinet, and move
the cabinet to the installation position.
7. Assemble the cabinet in the reverse order after the cabinet is moved to the installation position.
NOTICE
Attach the thermal insulation foam to pipe joints after water is injected and air is exhausted.
3.5 Securing Equipment
1. Shock absorption pads need to be attached to the top of the bases.
2. For a single-door and double-door cabinet, tighten the four screws on both sides.
3. Eight screws need to be tightened to secure a quadruple-door cabinet. Tighten the four
screws at both ends of the cabinet and one diagonal line of each of the two modules in
the middle.
8