Polaris RZR XP Service Manual page 164

ENGINE / COOLING SYSTEM
5. Using a dial bore gauge, measure big end I.D. in two
directions shown. Remove bearings when taking
q
measurements .
compare to specifications.
6. Refer to the number printed onto the side of the
connecting rod, closest to the small bore end. This
number represents the bore diameter.
7. The table below lists the big end bore diameter
specifications.
Connecting Rod Big End Bore Diameters
1
1.8892 -
1.8895"
(47.987 -
47.994 mm) 48.001 mm)
8. Whether using new connecting rods or re-installing
the original ones, refer to the bearing selection chart
provided in the "Connecting Rod Bearing Selection"
procedure in this chapter.
3.82
Record measurements
2 3
1.8896 - 1.8898 -
1.8898" 1.8901"
(47.995 - (48.002 -
48.008 mm)
and
9929419 R02 - 2018-2019 RZR XP / XP 4 Turbo S Service Manual
© Copyright Polaris Industries Inc.