Prop Shaft Assembly View; Support Bearing Replacement; U-Joint Disassembly - Polaris RZR XP Service Manual

PROP SHAFT ASSEMBLY VIEW

q
Support Bearing (not
replaceable)
w
Cross & Bearing

SUPPORT BEARING REPLACEMENT

1. Remove front prop shaft from the vehicle (see Prop
Shaft Removal page 7.21).
2. Using a hydraulic press, remove support bearing and
isolator bearing support as an assembly.
3. Clean the bearing mounting surface on the shaft.
4. Install new support bearing and isolator bearing
support assembly onto the end of the prop shaft.
9929419 R02 - 2018-2019 RZR XP / XP 4 Turbo S Service Manual
© Copyright Polaris Industries Inc.
e
Slip Yoke
r
Transmission Coupler
Yoke
5. Using a hydraulic press, install the support bearing
assembly onto the prop shaft.
IMPORTANT
The notch on the bearing support should be oriented as
shown.
6. Install front prop shaft into the vehicle (see Prop Shaft
Installation page 7.27).

U-JOINT DISASSEMBLY

CAUTION
Always wear eye protection.
1. Remove external snap ring
caps.
NOTE
If yoke or bearing is removed, cross bearing must be
replaced. Note orientation of grease fitting (if equipped)
and mark inner and outer yoke for correct re-positioning
during installation.
FINAL DRIVE
7
q
from all four bearing
7.25