Table of Contents
Advertisement
Steps
1. Place the I/O cover on the display-assembly base.
2. Align the screw holes on the I/O cover with the screw holes on the display-assembly base.
3. Replace the two screws (M3x5) that secure the I/O cover to the display-assembly base and snap the I/O cover back into
place.
Next steps
1. Install the
back
cover.
2. Install the stand.
3. Follow the procedure in
Stand hinges
Removing the stand hinges
Prerequisites
1. Follow the procedure in
2. Remove the stand.
3. Remove the
back
cover.
4. Remove the
I/O
cover.
5. Remove the
system-board
NOTE:
For replacement of stand or stand hinges, the replacement kit is shipped with both stand and stand hinges, and you
must replace both of these components together. Refer to the procedure for
About this task
The following image indicates the location of the stand hinges and provides a visual representation of the removal procedure.
After working inside your
Before working inside your
shield.
computer.
computer.
Removing and installing Customer Replaceable Units (CRUs)
removing the stand
and
installing the
stand.
51
Advertisement
Table of Contents
