Steps
1. Align the screw holes on the I/O cover with the screw holes on the display-assembly base.
2. Replace the five screws (M3x5) that secure the I/O cover to the display-assembly base and snap the I/O cover back into
place.
Next steps
1. Install the
back
cover.
2. Install the stand.
3. Follow the procedure in
Hinges
Removing the display hinges
Prerequisites
1. Follow the procedure in
2. Remove the stand.
3. Remove the
back
cover.
4. Remove the
I/O
cover.
NOTE:
For replacement of stand or display hinges, the replacement kit is shipped with both stand and display hinges, and
you must replace both of these components together. Refer to the procedure for
stand.
About this task
The following image indicates the location of the display hinges and provides a visual representation of the removal procedure.
After working inside your
Before working inside your
computer.
computer.
removing the stand
Removing and installing components
and
installing the
19