Removing The M.2 2280 Solid-State Drive - Dell W29C Service Manual
Hide thumbs
Also See for W29C:
- Owner's manual (119 pages) ,
- Service manual (87 pages) ,
- Setup and specifications (27 pages)
Table of Contents
Advertisement
3. Slide the solid-state drive into the M.2 card slot on the system board.
4. Replace the screw (M2x3.5) that secures the solid-state drive to the system board.
Next steps
1. Install the
system-board
2. Install the
I/O
cover.
3. Install the
back
cover.
4. Install the stand.
5. Follow the procedure in
Removing the M.2 2280 solid-state drive
Prerequisites
1. Follow the procedure in
2. Remove the stand.
3. Remove the
back
cover.
4. Remove the
I/O
cover.
5. Remove the
system-board
About this task
NOTE:
The M.2 card installed on your computer will depend on the configuration ordered. The supported card
configurations on the M.2 card slot are:
● M.2 2230 solid-state drive
● M.2 2280 solid-state drive
NOTE:
This procedure applies only to computers shipped with an M.2 2280 solid-state drive.
The following image indicates the location of the solid-state drive and provides a visual representation of the removal procedure.
Steps
1. Remove the screw (M2x3.5) that secures the solid-state drive to the system board.
2. Slide and remove the solid-state drive from the M.2 card slot on the system board.
32
Removing and installing components
shield.
After working inside your
Before working inside your
shield.
computer.
computer.
Advertisement
Table of Contents
