Table of Contents
Advertisement
Steps
1. Remove the 10 screws (M3x4.5) that secure the right and left stand hinges to the display-assembly base.
2. Lift the stand hinges off the display-assembly base.
Installing the stand hinges
Prerequisites
If you are replacing a component, remove the existing component before performing the installation procedure.
NOTE:
For replacement of stand or stand hinges, the replacement kit is shipped with both stand and stand hinges, and you
must replace both of these components together. Please refer to the procedure for
stand.
About this task
The following image indicates the location of the stand hinges and provides a visual representation of the installation procedure.
52
Removing and installing Customer Replaceable Units (CRUs)
removing the stand
and
installing the
Advertisement
Table of Contents
