Table of Contents
Advertisement
Next steps
1. Install the
system-board
2. Install the
I/O
cover.
3. Install the
back
cover.
4. Install the stand.
5. Follow the procedure in
Retractable-camera assembly
Removing the retractable-camera assembly
Prerequisites
1. Follow the procedure in
2. Remove the stand.
3. Remove the
back
cover.
4. Remove the
I/O
cover.
5. Remove the
system-board
About this task
The following image indicates the location of the retractable-camera assembly and provides a visual representation of the
removal procedure.
Steps
1. Disconnect the camera cable from the system board.
2. Peel the tape that secures the camera cable to the display-assembly base.
3. Remove the two screws (M3x5) that secure the retractable-camera assembly to the display-assembly base.
4. Remove the retractable-camera assembly from the display-assembly base.
66
Removing and installing Customer Replaceable Units (CRUs)
shield.
After working inside your
Before working inside your
shield.
computer.
computer.
Advertisement
Table of Contents
