Figure 21. Removing the stand hinges
Steps
1. Remove the 10 screws (M3x4.5) that secure the right and left stand hinges to the display-assembly base.
2. Lift the stand hinges off the display-assembly base.
Installing the stand hinges
Prerequisites
If you are replacing a component, remove the existing component before performing the installation procedure.
NOTE:
For replacement of stand or stand hinges, the replacement kit is shipped with both stand and stand hinges. Both
components are replaced together. Refer to the procedure for
About this task
The following image indicates the location of the stand hinges and provides a visual representation of the installation procedure.
removing the stand
Removing and installing Customer Replaceable Units (CRUs)
and
installing the
stand.
49