Installing the retractable-camera assembly
Prerequisites
If you are replacing a component, remove the existing component before performing the installation procedure.
About this task
The following image indicates the location of the retractable-camera assembly and provides a visual representation of the
installation procedure.
Figure 38. Installing the camera
Steps
1. Slide and place the retractable-camera assembly on the display-assembly base.
2. Replace the two screws (M3x5) that secure the retractable-camera assembly to the display-assembly base.
3. Adhere the tape that secures the camera cable to the display-assembly base.
4. Connect the camera cable to the system board.
Next steps
1. Install the
system-board
2. Install the
I/O
cover.
3. Install the
back
cover.
4. Install the stand.
5. Follow the procedure in
Fan
Removing the fan
Prerequisites
1. Follow the procedure in
64
Removing and installing Customer Replaceable Units (CRUs)
shield.
After working inside your
Before working inside your
computer.
computer.