Installing The Stand - Dell Inspiron 27 7720 All-in-One Owner's Manual

Figure 14. Removing the stand
Steps
1. Locate the tab on the stand, and push a scribe into the tab to release the stand from the display-assembly base.
2. Lift the stand off the display-assembly base.

Installing the stand

Prerequisites
If you are replacing a component, remove the existing component before performing the installation procedure.
NOTE: The following procedure is applicable for both Y stand and Isosceles stand.
NOTE: For replacement of stand or stand hinges, the replacement kit is shipped with both stand and stand hinges. Both
components are replaced together. Refer to the procedure for
About this task
The following image indicates the location of the stand and provides a visual representation of the installation procedure.
removing the stand
Removing and installing Customer Replaceable Units (CRUs)
and installing the stand.
43