Fujitsu ETERNUS AF Series Configuration Manual page 36

2. Installation
Installing in a Rack
• Attachment procedure
Clip the M6 cage nut tabs into the desired hole from the inside.
Top view
3
Attach the L-shaped brackets to the power synchronized unit.
Use four M3 flat head screws to attach the L-shaped brackets to the power synchronized unit on both sides.
M3 flat head screws
L-shaped bracket
4
Install the power synchronized unit in the rack.
Use four M6 cross recessed head screws with captive washer to fasten the power synchronized unit in the
rack.
M6 cross recessed head
screws with captive washer
(Rear rack pillars)
FUJITSU Storage ETERNUS AF, ETERNUS DX Configuration Guide (Power Synchronized Unit)
M6 cage nut
Rack pillar (square)
L-shaped bracket
M6 cross recessed head screws
with captive washer
Copyright 2019 FUJITSU LIMITED
M3 flat head screws
36
P3AM-8012-14ENZ0