4.
Connection and Settings
Connecting to the ETERNUS DX/AF
3
When two or more AC sensor units are connected, connect the AC sensor units with the AC sen-
sor port connection cables.
3-1
Connect the AC sensor port connection cable to the other port on the branch connector.
AC sensor port connection cable
3-2
Connect the connector at the other end of the AC sensor port connection cable to another AC sensor
unit.
AC sensor port connection cable
•
Up to 14 AC sensor units can be connected.
•
Do not attach a termination resistor to the branch connector on the AC sensor unit. Doing so makes
operations unstable.
Connecting to the ETERNUS DX/AF
Connect the power synchronized unit to the ETERNUS DX/AF with the RS232C cable.
Two RS232C cables (1m) are provided with a power synchronized unit. If the length of the cable is too short or
three or more cables are required, purchase more RS232C cables.
Up to four ETERNUS DX/AF storage systems can be connected to each power synchronized unit. When power syn-
chronized units are cascaded, up to eight ETERNUS DX/AF storage systems can be connected.
FUJITSU Storage ETERNUS AF, ETERNUS DX Configuration Guide (Power Synchronized Unit)
Branch connector
57
Copyright 2019 FUJITSU LIMITED
End of procedure
P3AM-8012-14ENZ0