Table of Contents
Advertisement
Color Calibration
132
To perform Bias Adjustment:
1a
If you wish to adjust the density for all colors
simultaneously, perform the following, then go to
1) Repeat steps 1 through 3 in "To print a color
calibration page:" on
Calibration Offset is displayed in the LCD panel.
2) Press the Enter button.
0* (–5 to 5) is displayed in the LCD panel.
3) Press the Continue/Forward or Cancel/Left button
to darken/lighten all the colors.
To make the color density setting of the Color Calibration Page
darker or lighter by 1 level, increase or decrease a value of the
Calibration Offset by 3 by pressing the Continue/Forward or
Cancel/Left button.
For example when Calibration Offset is 0:
•
If you wish to make the density setting darker by 1 level:
—Select 3 by pressing the Continue/Forward button 3 times.
•
If you wish to make the density setting lighter by 1 level:
—Select –3 by pressing the Cancel/Left button 3 times.
4) Press the Enter button.
CYAN is displayed in the LCD panel.
5) Press the Continue/Forward button 4 times.
Calibration Test Print is displayed in the LCD panel.
1b
If you wish to adjust the density for each color
independently, perform the following, then go to
1) Repeat steps 1 through 3 in "To print a color
calibration page".
2) Press the Continue/Forward button.
CYAN is displayed in the LCD panel.
3) Press the Enter button.
0* (–10 to 10) is displayed in the LCD panel.
page
129.
step
2.
step
2.
Advertisement
Table of Contents
