Pin Description - Philips PDIUSBD12 Product Data

Usb interface device with parallel bus
Hide thumbs Also See for PDIUSBD12:
Table of Contents

Advertisement

Philips Semiconductors

3.2 Pin description

9397 750 09238
Product data
Table 1:
Pin description
[1]
Symbol
Pin
Type
DATA <0>
1
IO2
DATA <1>
2
IO2
DATA <2>
3
IO2
DATA <3>
4
IO2
GND
5
P
DATA <4>
6
IO2
DATA <5>
7
IO2
DATA <6>
8
IO2
DATA <7>
9
IO2
ALE
10
I
CS_N
11
I
SUSPEND 12
I,OD4
CLKOUT
13
O2
INT_N
14
OD4
RD_N
15
I
WR_N
16
I
DMREQ
17
O4
DMACK_N 18
I
EOT_N
19
I
RESET_N
20
I
GL_N
21
OD8
XTAL1
22
I
XTAL2
23
O
V
24
P
CC
D−
25
A
D+
26
A
Rev. 08 — 20 December 2001
USB interface device with parallel bus
Description
Bit 0 of bidirectional data. Slew-rate controlled.
Bit 1 of bidirectional data. Slew-rate controlled.
Bit 2 of bidirectional data. Slew-rate controlled.
Bit 3 of bidirectional data. Slew-rate controlled.
Ground.
Bit 4 of bidirectional data. Slew-rate controlled.
Bit 5 of bidirectional data. Slew-rate controlled.
Bit 6 of bidirectional data. Slew-rate controlled.
Bit 7 of bidirectional data. Slew-rate controlled.
Address Latch Enable. The falling edge is used to close the
latch of the address information in a multiplexed address/ data
bus. Permanently tied LOW for separate address/ data bus
configuration.
Chip Select (Active LOW).
Device is in Suspend state.
Programmable Output Clock (slew-rate controlled).
Interrupt (Active LOW).
Read Strobe (Active LOW).
Write Strobe (Active LOW).
DMA Request.
DMA Acknowledge (Active LOW).
End of DMA Transfer (Active LOW). Double up as V
EOT_N is only valid when asserted together with DMACK_N
and either RD_N or WR_N.
Reset (Active LOW and asynchronous). Built-in Power-on reset
circuit present on chip, so pin can be tied HIGH to V
GoodLink LED indicator (Active LOW)
Crystal Connection 1 (6 MHz).
Crystal Connection 2 (6 MHz). If external clock signal, instead
of crystal, is connected to XTAL1, then XTAL2 should be
floated.
Voltage supply (4.0 − 5.5 V).
To operate the IC at 3.3 V, supply 3.3 V to both V
pins.
USB D− data line.
USB D+ data line.
PDIUSBD12
sensing.
BUS
.
CC
and V
CC
© Koninklijke Philips Electronics N.V. 2001. All rights reserved.
OUT3.3
3 of 35

Advertisement

Table of Contents
loading

Table of Contents