Adjusting Hole Positions In Feeding Direction - Canon Finisher-AK1 Service Manual

5
Adjustment > Auxiliary Adjustment > Adjusting Hole Positions in Feeding Direction

Adjusting Hole Positions in Feeding Direction

Execute this adjustment to adjust the punch hole position at paper edge.
Be sure to execute this adjustment for both the left and the right stopper units at the same
time.
1) Remove the punch unit.
2) Remove the 2 punch stopper units [1].
• 2 screws [2]
3) Remove the spring [1] (1pc each).
5 Adjustment > Auxiliary Adjustment > Adjusting Hole Positions in Feeding Direction
[2]
[1]
F-5-315
[1]
F-5-316
4) Loosen the screw [1] to adjust position of the stopper plate [3] by following the scale of the
engraved line [2].
• Engraved line
[A]: adjustment position at the time of shipment
[B]: not used
[C]: scale for adjustment
1 increment shifts the punch position toward the paper edge by 1mm.
[A]
[1]
[3]
CAUTION: Point to note at installation after the adjustment
Perform installation while pushing the lower area of the stopper plate [1].
(Install with the stopper [2] pushed in the frame)
[1]
[B]
[C]
[2]
F-5-317
[2]
F-5-318
5-128
5-128