Canon Finisher-AK1 Service Manual page 353

6) Remove the Rear Cover.
• 2 Screws (Loosen)
• 6 Screws
x6
7) Measure the height [A] from the floor (where caster is landing) to the upper surface of the
bottom plate using a scale, and check that the height is within 86.3 +/- 0.3 mm.
If the height is not within the range, execute step 7) and later.
7
Installation > Adjustment > Height Adjustment > Height Adjustment
Loosen
F-7-103
[A]
86.3 0.3mm
F-7-104
7 Installation > Adjustment > Height Adjustment > Height Adjustment
8) Loosen the caster's Fixing Nut with the spanner in the direction of [A].
CAUTION:
When loosening the caster Fixing Nut at the front side of the Saddle Finisher, be sure to
insert the spaner into the opening just below the Saddle botom plate.
Saddle Bottom Plate
7-37
Fixing Nut
[A]
F-7-105
Fixing Nut
F-7-106
7-37