Removing The Feed Motor Driver Pcb; Removing The Saddle Stitcher Controller Pcb - Canon Finisher-AK1 Service Manual

4
Parts Replacing and Cleaning > Electric Control Assembly > Removing the Saddle Stitcher Controller PCB > Procedure

Removing the Feed Motor Driver PCB

■ Preparation
1) Remove the Rear Upper Cover (Right).(Refer to page 4-21)
2) Remove the Rear Upper Cover (Left).(Refer to page 4-21)
3) Remove the Rear Cover.(Refer to page 4-20)
4) Remove the Neat Stack Driver PCB.(Refer to page 4-24)
■ Procedure
1) Remove the Feed Motor Driver PCB [1].
• 17 Connectors [2]
• 6 Screws [3]
[3]
[2]
[3]
[2]
[3]
4 Parts Replacing and Cleaning > Electric Control Assembly > Removing the Saddle Stitcher Controller PCB > Procedure
[2]
[3]
[1]
[3]
[2]
[3]
[2]
F-4-35

Removing the Saddle Stitcher Controller PCB

■ Preparation
1) Open the Front Cover.
2) Pull out the Saddle Unit.
3) Remove the Saddle Inner Cover (Lower).(Refer to page 4-89)
■ Procedure
1) Remove the Saddle Stitcher Controller PCB Cover [1].
• 6 Screws [2]
[1]
4-25
[2]
[2]
F-4-36
4-25