Canon Finisher-AK1 Service Manual page 345

4) Lower the Latch Plate (Front) and fix it.
• 1 Screw (Use the Screw removed in the step 7) of "Before Installing the Finisher")
5) Close the Finisher Front Cover.
6) Move the Latch Plate (Rear) in the direction of the arrow and insert it to the pin to fix it.
• 1 Screw (Use the Screw removed in the step 9) of "Before Installing the Finisher")
Latch Plate (Rear)
Screw
7
Installation > Installation Procedure > Connecting with the Document Insertion Unit
Latch Plate (Front)
Screw
F-7-80
F-7-81
7 Installation > Installation Procedure > Connecting with the Document Insertion Unit
7) Check the height between Finisher and the Document Insertion Unit.
Document Insertion Unit
Finisher
8) Install the Rear Small Cover. (1 Screw)
9) Install the Shunt Cable.
• 2 Screws (RS tightening; M4x10)
x2
7-29
F-7-82
F-7-83
7-29