Husqvarna DXR140 Operator's Manual page 44

Mountings
General
Check that all components are properly secured by
feeling, pulling etc. Keep a look out for wear damage. This
can be caused by components coming loose.
• A bolted joint that is secured with adhesive should not
be tightened. Simply check that it is tight. If a glued
bolted joint has come loose, clean the threads before
fresh adhesive is applied.
• Check the shafts with respect to mounting/locking.
Check expanding shafts by tightening with a torque
wrench.
• Locking pins must be checked with respect to damage
and mounting.
Shafts
• The design of the expanding shafts ensures that there
is not too much play provided that they are tightened
regularly. New expanding shafts must be tightened
frequently until they have bedded in. Wear damage on
the expanding shaft's sleeve is a typical sign that they
have not been tightened correctly or sufficiently often.
• If an expanding shaft has slipped out of position it is
important that it is centred before being retightened
again.
44 – English
MAINTENANCE AND SERVICE
Tightening torque
Use abutment when torquing through shafts to avoid the
shaft rotating.
Position
A Shafts, arm system, outriggers
B Tool against adapter plate
C Support leg bracket (4xM16)
D Support leg bracket (2xM12)
Nm
175
197
167
81