Operation - Husqvarna 2-20DT Global Operator's Manual

• Do not make modifications to the product.
Modifications that are not approved by the
manufacturer can cause serious injury or death.
• Replace damaged, worn or broken parts.
• Do not use a pressure washer to clean the product.
• Only use lint-free cleaning cloths.
• Always use original accessories and spare parts.
Accessories and spare parts that are not approved
Introduction
WARNING:
product, you must read and understand the
safety chapter.
To do before you operate the product
1. Read the operator's manual carefully and make sure
that you understand the instructions.
2. Read the operator's manual for the dust extractor
carefully and make sure that you understand the
instructions.
3. If the product is operated in connection with a power
source, make sure that you read and understand the
operator's manual of that power source.
4. Use personal protective equipment. Refer to
Personal protective equipment on page 8 .
5. Make sure that only approved persons are in the
work area.
6. Do daily maintenance. Refer to
schedule on page 22 .
7. Make sure that the product is assembled correctly
and is not damaged.
8. Make sure that all bolts, screws and nuts are
tightened.
9. Make sure that the blastwheels, feed spouts, liners
and sealings are not damaged or worn out. Replace
the parts when 75% of the blade thickness has been
worn away.
10. Make sure that the separator is not damaged.
11. Make sure that the separator is filled with abrasive
up to the separator tray.
12. Put the product on the work area. Make sure that the
surface is level. Make sure that the transportation of
the product to and in the work area is done safely
and correctly. Refer to
13. Connect a dust extractor to the product. Refer to
connect a dust extractor on page 17 .
14. Make sure that the ON/OFF switch is in OFF position
before you connect the product to a power supply.
15. Connect the product to a power source. Refer to
connect the product to a power source on page 17 .
12
Before you operate the
Maintenance
Transportation on page 28 .
by the manufacturer, can cause serious injury or
death.
• After maintenance, do a check of the vibration level
in the product. If it is not correct, speak to an
approved service agent.
• Let an approved service agent do servicing on the
product regularly.

Operation

16. Make sure that the height of the brush seals are 1
mm/0.04 in. above the surface.
17. Make sure that the height of the magnetic seals are
8–10 mm/0.3–0.4 in. above the surface.
Drive system
The drive system is used during operation and allows
the product to be moved around with the traction wheel.
To move the product with the drive system on
Refer to
page 28 .
Always engage the drive system during operation.
To engage and disengage the drive
system
WARNING:
from rotating parts. Be very careful when
you attach the quick release pin.
CAUTION:
system when the product is parked on level
surface.
If it is necessary to move the product manually with the
motor off, the drive system must be disengaged. The
drive system is disengaged and engaged by the quick
release pin. The quick release pin is adjacent to the
traction wheel. Refer to
page 3 or Product overview 2-30DS Global on page 4 .
1. Turn the ON/OFF switch to ON.
To
To
Keep your hands away
Only disengage the drive
Product overview 2-20DT on
2037 - 001 - 07.02.2023