Husqvarna 2-20DT Global Operator's Manual page 29

2. Pull down the handle to lift the product from the
surface.
3. Set and adjust the movement speed with the speed
control dial (C).
A
4. Push and hold the drive system lever (D) to move
the product rearward.
5. Push and hold the overdrive button (A) to move at
maximum speed.
6. Push and hold the forward button (B) to move the
product forward.
To move the product up and down a
ramp
WARNING:
move the product up and down ramps. The
product is heavy and there is a risk of injury
if the product falls or moves too quickly.
WARNING:
slope, always use a winch. Do not walk or
stay below or near the product.
• To move the product down a ramp, operate the
product forward slowly.
• To move the product up a ramp, operate the product
rearward slowly.
• Do not turn the product to the left or to the right more
than 45° on a ramp.
2037 - 001 - 07.02.2023
B
C
D
Be very careful when you
For ramps with a steep
To lift the product
WARNING:
equipment has the correct specification to
lift the product safely. The type plate on the
product shows the product weight.
WARNING:
or near a lifted product. Keep bystanders
away from the work area.
WARNING:
product. Make sure that the lifting eye is
correctly installed and not damaged.
1. Attach the lifting equipment at the lifting eyes.
2. Lift the product safely. Hold the handle until the
product is lifted off the ground.
To attach the product to a
transportation vehicle
Use the lifting eyes to attach the product to the
transportation vehicle.
1. Attach the tie-down straps in the lifting eyes.
2. Attach and tighten the tie-down straps to the
transportation vehicle.
Storage
CAUTION:
storage outdoors. Always keep the product
indoors.
• Keep the product in a dry and frost-free area.
Make sure that the lifting
Do not walk or stay below
Do not lift a damaged
Do not put the product in
29