Husqvarna 2-20DT Global Operator's Manual page 21

6. Turn the control cage (B) counterclockwise, if the
hotspot is too much on the left side.
7. Make sure that the hotspot is equaly applied on the
surface for correct adjustment.
2037 - 001 - 07.02.2023
8. Tighten the cage clamps when the control cage is in
correct position.
9. Attach the feedspout.
To stop the product
1. Push the abrasive control lever to close the abrasive
To operate the abrasive valves on
valve. Refer to
page 14 .
2. Push the OFF button to stop the blast motors.
3. Turn the ON/OFF switch to OFF position.
4. Disconnect the power plug from the power supply.
5. Stop the dust extractor. Refer to the operator's
manual of the dust extractor.
21