Iec 61850 Edition 1 / Edition 2 Mapping - ABB Relion SAM600 Communication Protocol Manual

Section 1
Introduction
For example, the function can be enabled and disabled with the Operation setting.
• Each function block symbol shows the available input/output signal.
•
•
• Dimensions are provided both in inches and millimeters. If it is not specifically mentioned then
the dimension is in millimeters.
1.5

IEC 61850 edition 1 / edition 2 mapping

Function block names are used in ACT and PST to identify functions. Respective function block
names of Edition 1 logical nodes and Edition 2 logical nodes are shown in the table below.
Table 1:
Function block name
-
AGSAL
ALMCALH
ALTIM
ALTMS
ALTRK
BTIGAPC
DPGAPC
DRPRDRE
INDCALH
ITBGAPC
L4UFCNT
LD0LLN0
LPHD
MVGAPC
QCBAY
RCHLCCH
SCHLCCH
SCSWI
SLGAPC
SMPPTRC
SP16GAPC
SPC8GAPC
SPGAPC
SSCBR
SSIMG
SSIML
Table continues on next page
6
the character ^ in front of an input/output signal name indicates that the signal name may
be customized using the PCM600 software.
the character * after an input signal name indicates that the signal must be connected to
another function block in the application configuration to achieve a valid application
configuration.
IEC 61850 edition 1 / edition 2 mapping
Edition 1 logical nodes
© 2017 - 2021 Hitachi Power Grids. All rights reserved
-
AGSAL
SECLLN0
ALMCALH
-
-
-
B16IFCVI
DPGGIO
DRPRDRE
INDCALH
IB16FCVB
L4UFCNT
LLN0
LPHD
MVGGIO
QCBAY
RCHLCCH
SCHLCCH
SCSWI
SLGGIO
SMPPTRC
SP16GGIO
SPC8GGIO
SPGGIO
SSCBR
SSIMG
SSIML
1MRK 511 441-UEN Rev. C
GUID-C5133366-7260-4C47-A975-7DBAB3A33A96 v9
Edition 2 logical nodes
ALGOS
AGSAL
ALMCALH
ALTIM
ALTMS
ALTRK
BTIGAPC
DPGAPC
DRPRDRE
INDCALH
ITBGAPC
L4UFCNT
-
MVGAPC
BAY/LLN0
RCHLCCH
SCHLCCH
SCSWI
SLGAPC
SMPPTRC
SP16GAPC
SPC8GAPC
SPGAPC
SSCBR
SSIMG
SSIML
Switchgear control unit SAM600-IO
Communication protocol manual