Steps
1. Place the SD card reader on the system board ensuring the SD card reader sits flush on the connector on the system board.
2. Replace the two M3x5 screws securing the SD card reader to the system board.
3. Route the PSU power cable from over the SD card reader.
Next steps
1. Install the
HDD/ODD
2. Install the
front
bezel.
3. Install the
side
cover.
4. Follow the procedure in
Power supply unit
Removing the power-supply unit
Prerequisites
1. Follow the procedure in
2. Remove the
side
cover.
3. Remove the
front
bezel.
4. Remove the
HDD/ODD
NOTE:
Note the routing of all cables as you remove them so that you can route them correctly while you are replacing the
power-supply unit.
About this task
The following images indicate the location of the power-supply unit and provides a visual representation of the removal
procedure.
42
Disassembly and reassembly
Bracket.
After working inside your
Before working inside your
bracket.
computer.
computer.