Electrical connections
Introduction
Connecting HMI
Connecting opti-
cal detector
Connecting exten-
sion module
(option)
Connecting Cur-
rent Sensing Unit
(option)
This chapter describes how to connect the electrical connections to the Arc
Monitor and to the Arc Guard System.
Warning!
Make sure that supply voltage is switched off!
To read about connecting HMI; See the chapter "Mounting the HMI on door"
on page - 26.
To read about connecting optical detector ; See the chapter "Connecting
optical detectors" on page - 32.
To read about connecting extension modules; See the chapter "Connecting
extension module (option)" on page - 33.
To read about connecting Current Sensing Unit ; See the chapter "Connect-
ing CSU cable" on page - 34.
Installation
35