LG LDE3011ST Owner's Manual page 36

Electric double oven range
Hide thumbs Also See for LDE3011ST:
Table of Contents

Advertisement

O P E R AT I N G I N S T RU C T I O N S
SELF CLEAN
If it becomes necessary to stop or interrupt a
selfcleaning cycle due to excessive smoke or fire in the
oven:
or
NOTE:
When using the Self Clean feature:
Self Clean can only be run in one oven at a time.
• A Self Clean cycle cannot be started if Oven Lockout
feature is active.
• Once the SELF CLEAN is set, the oven door will lock
automatically. You will not be able to open the oven
door until the oven is cooled. The lock will release
automatically.
• Once the door has been locked the LOCKED indicator
light will stop flashing and remain on.
Allow about 15 seconds for the oven door lock to close.
• If your clock is set for normal 12 hours display mode
the Delayed Self Clean can never be set to start more
than 12 hours in advance. To set for a delayed Self
Clean cycle 12- 24 hours in advance, see page 18 for
instructions to set the control for the 24 hours time of
day display mode.
36
(For both the Upper & Lower oven)
Touch UPPER & LOWER CLEAR
OFF.
After the oven has cooled down,
the DOOR LOCK will
automatically release allowing you
to open the oven door.
(cont')
When the self clean cycle is done
• It will not be possible to open the oven door until oven
temperature has cooled.
• It is recommend to use 3 hours cycle for average soil,
and 5 hours cycle for heavy soil.
• Additional time is needed to cool the oven down.
Therefore, the oven door will not release from the lock
position until after it has cooled.
When the self clean cycle is done
• You may notice some white ash in the oven. Wipe it off
with a damp cloth or a soap-filled steel wool pad after
the oven cools.
If the oven is not clean after one clean cycle, repeat the
cycle.
• If oven racks were left in the oven and do not slide
smoothly after a clean cycle, wipe racks and rack
supports with a small amount of vegetable oil to make
them glide easier.
• Fine lines may appear in the porcelain because it went
through heating and cooling. This is normal and will not
affect performance.

Advertisement

Table of Contents
loading

Table of Contents