Changing The Default View; Using Function Buttons; Using The Single-Line Diagram - Hitachi 650 Series Operation Manual

1MRK500128-UEN Rev. H
5.1.9.3

Changing the default view

The default view of the display is Main menu unless set otherwise.
1.
Select Main menu /Configuration /HMI /Screen /SCREEN:1 and press
2.
Change the default view with
3.
Press
5.1.10

Using function buttons

The function buttons can be configured either as menu shortcuts or control buttons. The buttons are
functional only when the function button panel is visible.
1. Press any function button to open the function button panel.
On the first press of a button, the panel opens but no other action is taken.
GUID-C98D972D-D1D8-4734-B419-161DBC0DC97B V1 EN-US
Figure 23:
2. Press the wanted function button.
•
•
3.
Press
The panel is also closed after pressing a function button configured for a menu shortcut.
The function buttons are configured with PCM600.
5.1.11

Using the single-line diagram

The single-line diagram is created with PCM600.
650 series
Operation manual
to confirm the selection.
Function button panel
Press the wanted function button to jump to a certain menu item.
The menu opens immediately upon pressing the button.
Press the wanted function button for at least 0.5 s to initiate a control signal. The action is
taken once.
To repeat the action, press the button again. If the button is pressed less than 0.5 s, no
action is taken.
to close the function button panel.
© 2017 - 2023 Hitachi Energy. All rights reserved
or .
IEC13000281-1-en.vsd
Section 5
Using the HMI
GUID-068D31CD-D53C-48F4-817C-EAD8E33C0A0C v8
.
GUID-92DE8931-3340-4838-BC8D-33FDF08CD4D4 v5
GUID-72AC5BD6-D1B5-46D4-83B9-A10870125FCF v7
39