Disassembly
Disassembly
G
G
Removing and Replacing the Stylus
Removing and Replacing the Battery
E
18
The procedures in this section provide instructions for the disassembly of a A388c
telephone. Tools and equipment used for the phone are listed in Table 2, preceding.
Many of the integrated devices used in this equipment are vulnerable to damage
from electrostatic discharge (ESD). Ensure adequate static protection is in place
when handling, shipping, and servicing the internal components of this equipment.
Avoid stressing the plastic in any way to avoid damage to either the plastic or
internal components.
1.
Grasp the stylus and pull straight out of the bottom of the telephone as shown
in Figure 4.
Figure 4. Removing the stylus
2.
To replace, insert the stylus, pointed end first, into the styles holder on the
bottom of the telephone. Push until fully seated in the holder.
All batteries can cause property damage and/or bodily injury such as burns if a
conductive material such as jewelry, keys, or beaded chains touch exposed terminals.
The conductive material may complete an electrical circuit (short circuit) and
become quite hot. Exercise care in handling any charged battery, particularly when
placing it inside a pocket, purse, or other container with metal objects.
1.
Ensure the phone is turned off.
2.
Slide the battery latch in the direction of the arrow as shown in Figure 5-1.
March 21, 2003
Product Family 0C81
STYLUS
011638-o
6809462A54