Motorola L6Q Installation Manual page 35

2.5
SIM and SD Cards
Each L6Q camera requires an active MicroSIM card to upload detections and a MicroSD card to
buffer detections in case of signal loss. A 32 GB MicroSD card is factory installed in each camera. If
purchased as part of a subscription, an active MicroSIM card is also factory installed in the camera.
Changing SIM cards does not require reprovisioning. For Agencies or Sites that choose to provide their
own SIM card, L6Q cameras support the following mobile carriers:
• Verizon Mobile
• AT&T Mobile
• FirstNet Mobile
CAUTION: A consumer grade SIM card that is not configured for use with L6Q cameras will
incur excessive voice billing charges from the carrier! Voice charges are considered legitimate
and cannot be disputed. Only approved Internet of Things (IoT) SIM cards configured for L6Q
data should be used with the L6Q camera. Contact Vigilant Support for questions regarding
cellular carriers and approved SIM cards.
2.5.1
Installing a SIM or SD Card
The MicroSIM and MicroSD card slots are located in the battery compartment of the camera.
Prerequisites: Obtain one or both:
• MicroSD Card
• MicroSIM Card
Procedure:
1 If the Battery Tray is inserted, remove it from the camera.
The camera is shipped without the battery tray inserted.
2 Identify the card slot types and proper card orientations.
Refer to the labels by each slot in the battery compartment.
Figure 5: MicroSIM and MicroSD Cards
3 Orient the card as indicated by the label and slide the card into the correct slot.
4 Press gently on the card until it clicks into place.
CAUTION: Do not forcefully insert the card into the slot. Doing so may damage the card
or the slot. If the card does not slide in easily, re-check the card orientation and slot type.
5 To remove a card, press gently until it clicks out of place.
MN010089A01-AB
Chapter 2 : Pre-Installation
35