Motorola L6Q Installation Manual page 57

Figure 16: Distances A and B
5 Select the number of lanes in the road being monitored by the camera: one or two.
6 Enter the previously determined distances A and B into the application.
3.6.2
Aiming and Securing the Camera
If an assistant is available to drive a testing vehicle through the capture zone, dispatch them at this
time.
Procedure:
1 Grip the camera with one hand while watching the video feed from the camera on the mobile
phone to adjust the aim.
2 As vehicles travel through the capture zone, continue adjusting the camera until three successful
green scans are made.
Orange or red scans will not apply to the successful scan count. After each scan, the Mobile
Companion application will play a chime sound.
3 When satisfied with the aiming results, hold the camera in place and use the Hex Key Tool to
lock in the position of the camera.
4 Remove the Mobile Phone Pouch and Mobile Phone.
5 Secure any power cables with the reusable zip ties and trim any carefully excess material from
the zip ties:
• If this is a Solar Panel deployment, secure the power cable above the camera.
MN010089A01-AB
Chapter 3 : Hardware Installation
57