Motorola L6Q Installation Manual page 39

Option Actions
Figure 8: AC Elbow Connector to Lower Power Port
2 Allow the internal Camera Batteries to fully charge.
During normal camera operation, the LED Status Indicator will appear solid green when the
battery is fully charged. For other LED power indications, see
3 Select one of the following options:
• If this is a Solar Panel deployment, go to
• If this deployment uses an other power option, go to
on page 40.
Postrequisites: The internal Camera Battery is fully charged and the LED Status Indicator is solid
green.
2.7.2
Charging Solar Panel Batteries
Use the included Solar Panel Battery AC Power Adapter to charge the Solar Panel Battery. If the solar
panel deployment calls for two batteries, each must be fully charged.
Prerequisites: Obtain the following:
• Solar Panel Battery AC Power Adapter
• Solar Panel Battery
Procedure:
1 Unscrew the cover from the battery tie port on the Solar Panel Battery.
2 Connect the charger to the port by rotating the connector until it seats into the port.
3 Secure the connector locking sleeve.
4 Plug the other end of the charger into a wall plug.
5 Allow the battery to fully charge.
Postrequisites: The Solar Panel Battery is fully charged.
LED Status
Charging Solar Panel Batteries on page
Pairing Cameras to Mobile Companion
MN010089A01-AB
Chapter 2 : Pre-Installation
Indicator.
39.
39