Dell P138G Service Manual page 123

Table 10. System setup options—Connection menu (continued)
Connection
WWAN Bus Mode
WLAN
Bluetooth
Contactless smartcard/NFC
Enable UEFI Network Stack
Wireless Radio Control
Control WLAN radio
Control WWAN radio
HTTPs Boot Feature
HTTPs Boot
HTTPs Boot Mode
Table 11. System setup options—Power menu
Power
Battery configuration
Advanced Configuration
Enable Advanced Battery Charge
Configuration
Peak Shift
Enable Peak Shift
USB PowerShare
Enable USB PowerShare
By default, the option enabled.
Set the interface type of the Wireless Wan (WWAN) card.
By default, the Bus Mode PCIe option is enabled.
Enable or disable the internal WLAN device
By default, the option enabled.
Enable or disable the internal Bluetooth device
By default, the option enabled.
Enable or disable the internal Contactless smartcard/NFC device
By default, the option enabled.
Enable or disable UEFI Network Stack and controls the on-board LAN
Controller.
By default, the Enable UEFI Network Stack option are enabled.
Sense the connection of the computer to a wired network and subsequently
disable the selected wireless radios (WLAN).
By default, the option is disabled.
Sense the connection of the computer to a wired network and subsequently
disable the selected wireless radios (WWAN).
By default, the option is disabled.
Enable or disable the HTTPs Boot feature.
By default, the HTTPs Boot option is enabled.
With Auto Mode, the HTTPs Boot extracts Boot URL from the DHCP. With
Manual Mode, the HTTPs Boot reads Boot URL from the user-provided data.
By default, the Auto Mode option is enabled.
Enables the computer to run on battery during peak power usage hours. Use
the table Custom Charge Start and Custom Charge Stop, to prevent AC
power usage between certain times of each day.
By default, the Adaptive option is enabled.
Enable or disable the advanced battery charge configuration.
By default, the Enable Advanced Battery Charge Configuration option is
disabled.
Enables the computer to run on battery during peak power usage hours.
By default, the Enable Peak Shift option is enabled.
Enable or disable the USB PowerShare.
BIOS setup 123